Can mils be a positive and a negative number? I've seen positive all the time. However by my operators rounds and readings, they are reporting negative. If I have a trip/alarm setpoint of (5/10)-mils for compressor vibration on a chiller, does that typically account for both magnitudes?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Typical Mils Vibration Question
- Thread starter mpeck1982
- Start date
electricpete
Electrical
When describing vibration magnitude, one would not normally use negative number.
However when describing thrust (axial) position of shaft, one might use negative number.
=====================================
(2B)+(2B)' ?
However when describing thrust (axial) position of shaft, one might use negative number.
=====================================
(2B)+(2B)' ?
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Question
- Locked
- Question