matrixman86
Electrical
When I mesh, every element shows its real constant type, in my case, R#, when meshing, it gets quite annoying to see a ton of R# around, how do I turn these labels off? I've looked under symbols and what not but to no avail.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Turning off element labels.
- Thread starter matrixman86
- Start date
- Status
Hi,
PlotControls -> Numbering -> Element Numbering by NONE (or / and show numbering by colors only).
If it's not your default behaviour, then almost certainly there is a command in the Ansys Start Directives File telling him to do so: I'd suggest to check in there...
Regards
PlotControls -> Numbering -> Element Numbering by NONE (or / and show numbering by colors only).
If it's not your default behaviour, then almost certainly there is a command in the Ansys Start Directives File telling him to do so: I'd suggest to check in there...
Regards
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question