Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TURN POSTPROCESSOR WITH HEIDENHAIN CONTROL

Thread starter LayKanae
Start date Apr 20, 2015

Status: Not open for further replies.

Apr 20, 2015

LayKanae

Industrial

Hello Guys

Does anyone has used or created a postprocesor for turning with TNC control
in NX ? is it posible?

I have not found any examples in postbuilder an i have problems starting from
zero in this post.

Do you know where can i find an example to start from of this post?

Thanks