Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Turn off cross section lines?

Status
Not open for further replies.

waiwiliki

Aerospace
Joined
Dec 9, 2002
Messages
19
Location
US
Where can I turn off the cross sectional cut away lines? I know there has to be a better term than "cut-away lines". I have a drawing where there are multiple parts shown in a simple cross section, these cut-away lines become cumbersome when dealing with numerous parts.

Thanks...

Wai
 
Are you asking how to remove the cross hatching from a section view? If so, you can change the spacing of the cross hatching to a very large value, say 1000. I know this is tedious , and there may be an easier method, but it works.
 
Yes, that is what I am aiming to do. Thanks for the advice.
 
Waiwiliki,

Another method is to select Excl Comp from the modify xhatch menu. This will turn off the cross hatching lines for a selected part and is available in assembly mode or drawing mode when a view of an assembly with a cross section has been created.

Happy Holidays,

B-) TheLowDown
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top