Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

tube

Status
Not open for further replies.
alf238

alf238

Mechanical
Dec 10, 2003
12
Hi everyone,

I make a hole into a tube (the outside diameter of the tube is 8mm and the inside diam. is 5.5mm), 1mm radius. I want to see the shape of the hole after the tube is flattened. How to do this in UG NX?

Thanks,
alf
 
Replies continue below

Recommended for you

Sort by date Sort by votes
If your tube is a straight cylinder, you can use the wrap/unwrap command.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

CAD2015
  • Locked
  • Question
CENTERLINE FROM A TUBE BODY 3
Replies
19
Views
6K
CAD2015
CAD2015
Kenja824
  • Locked
  • Question
NX1966? -- Centerlines of tubes? 1
Replies
2
Views
163
Kenja824
Kenja824
multicaduser
  • Locked
  • Question
journal to create tubes from sketch
Replies
2
Views
175
multicaduser
multicaduser
Gaortiz01
  • Locked
  • Question
Alternative Command for Tube Command to Generate a line with "Thickness" (image attached) 1
Replies
4
Views
165
mmauldin
mmauldin
NutAce
  • Locked
  • Question
Unbend Routing tube
Replies
6
Views
215
NutAce
NutAce

Part and Inventory Search

Sponsor

Back
Top Bottom