Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TUBE TO TUBESHEET MOCK UP PROCEDURE FOR HEAT EXCHANGER

Status
Not open for further replies.
S

sameerjoshi1969

Mechanical
Joined
Nov 9, 2024
Messages
1
We have a qualified tube-to-tubesheet mock-up procedure for tubes of 25.4mm OD * 2.77mm thickness.
All other parameters being the same, can i use it for tubes of 25.4mm OD * 3mm thickness
 
Status
Not open for further replies.

Similar threads

1athoti
  • Locked
  • Question Question
Heat Exchanger Efficiency
Replies
18
Views
1K
georgeverghese
georgeverghese
FluidME
  • Locked
  • Question Question
Ethylene Glycol detection in condensate stream for heat exchanger
Replies
10
Views
802
pierreick
pierreick
C
  • Question Question
How to Air-Seal Oval Tube into Hole!
Replies
5
Views
715
chuwiEngineer
C
stoerw
  • Locked
  • Question Question
Plate Heat Exchanger Discharge Temp Stratification
Replies
9
Views
682
stoerw
stoerw
W
  • Question Question
Orifice for dump line to liquid tank
Replies
10
Views
9K
Whatsanolet
W

Part and Inventory Search

Sponsor

Back
Top