My company is looking at using tabbed and slotted pieces of square and rectangular tubing for frame assemblies. The use of tabs and slots allows for a simplified mockup of parts. This would be a lot like Christmas morning assemblies "Insert tab A into slot B". I am looking for any possible standards or general practices concerning the use of tabs and slots, including possible size references, etc.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tube tabbing for assembly question
- Thread starter natebott
- Start date
Similar threads
- Question
- Question
