Thanks for the info on the new 3030. I'm sure it will take some getting use to and is a change from the 3o50 series. on our 5k,s we have made changes to the beam dilivery as well as techtables to increase cutting speeds, edge quality and no dross with parts dropping out of the skeletons up to 1.25 a36 carbon. we have tried the 1.50 and still needs some work but with a very busy day there is not much time to adjust the 1 1/2 carbon. we have found that there are many different ways to cut by making changes to the techtables and still end up with the same possitive result.