Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Truck Decontamination dry brushing or steam cleaning procedure

Status
Not open for further replies.

EnviroYIT

Civil/Environmental
Joined
May 22, 2013
Messages
3
Location
US
I am in the process of creating a description and detail of a decontamination area for truck tire cleaning. The trucks will be cleaned prior to leaving the project site. Does anyone have any ideas where I can find information on dry brushing? I haven't done this before and I haven't been able to find any background on this. Another option I have is to steam clean the vehicles as they leave the site. Does anyone have any ideas on the best design for the steam clean area to reduce mud and water recovery?

Any help would be much appreciated.

Thanks.
 
Are you cleaning because you just don't want soil on the public roadway, or is the material contaminated? If it is contaminated, you will need to collect the effluent if you steam clean, and test before you dispose of it.
 
Yes it is contaminated. We are planning on collecting effluent and using it as dust suppression on areas of the site where contaminated soil will remain. Do you know where I can find any design specs for this type of system?
 
In the past, the contractor has simply set up a poly ground cover, made sides of hay bales (covered with the poly), and sized it for the vehicles to be used. I've never seen it actually designed or drawn up. After cleaning, a laborer just used a wet vac to suck up the effluent and it was either piped to drums, or if lots of traffic, a temp holding tank.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top