Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Trouble with Hole Wizard Propagating Parts in Assembly

Thread starter Dissymmetry
Start date Apr 28, 2009

Status: Not open for further replies.

Apr 28, 2009

Dissymmetry

Mechanical

Anyone else have issues with the hole wizard propagating to the components? In the assembly without propagating it works perfectly. As soon as I set it to propagate, the holes move into random locations even though they are fully defined in a 3D sketch in the assembly.