Trouble using smart fasteners 1

[charliedurrant]

Hi,

I am new to solidworks and am having a great deal of trouble with smart fasteners. I just can't get it to recognise a series of concentric mated holes as one and simply put the nut on the end of the set screw. Does anyone have any ideas. The whole assembly is at

http://www.wilverley.com/assembly.zip

(virus checked, 400k)

...solid works 2006.


Charles

 

[SBaugh]

you have to use Hole wizard/Hole series or Smart fasteners will not recognize the holes. If you just made a bunch of cut holes in a few parts, that is not going to cut it.

Regards,

Scott Baugh, CSWP

http://www.scottjbaugh.com

faq731-376

 

[charliedurrant]

Thanks - that was it - one part had a mirrored hole that was not done using the hole wizard.

All working now.