Do you know of any commercially available software useful for the the design of small and medium power transformers? What about mechanical design programs for the tank alone ie stress etc? (beyond Autocad). Thanks for your advise. I didn't have much luck searching the web.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations LittleInch on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Transformer and/or Transformer Tank Design Software
- Thread starter bethbc
- Start date
SphincterBoy
Electrical
Our Waukesha Electric Systems units were designed with
Pro/E.
Some of our padmounted units were designed with AutoCAD.
I would say one of the commercial CAD packages is your
best bet. Sorry.
I think the best (and easiest to use) CAD program I've seen
(even beyond Solidworks) is Ashlar Vellum Cobalt. Cheaper too.
It core geometric engine was conceived by a draftsman for draftsmen.
Pro/E.
Some of our padmounted units were designed with AutoCAD.
I would say one of the commercial CAD packages is your
best bet. Sorry.
I think the best (and easiest to use) CAD program I've seen
(even beyond Solidworks) is Ashlar Vellum Cobalt. Cheaper too.
It core geometric engine was conceived by a draftsman for draftsmen.
- Status
Similar threads
- Locked
- Question