hookie1985
Industrial
Yea.. I was cutting some composite wood and needed the trace off but between each cut I had to lower it back to the material.. anybody know of a setting to stop that?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Trace off causes head to rise way high
- Thread starter hookie1985
- Start date
- Status
- Thread starter
- #3
When you did the program did you do it if it was 1/2 steel so the M102 line looks like M102(HRS0.500) and than change the material thickness on the cut condition page to 1.00? Because we set up a wood condition that every time we cut a sheet the head would retract and never come down next thing you know the head is 2 inches off the sheet. The cause was it never gave me a good post some lines were missing like the M103 (pierce line).
- Thread starter
- #6
hookie1985
Industrial
sorry it posted my password up there lol. I ran it on our old aluminum setting with nitrogen cranked up
- Status
Similar threads
- Locked
- Question