I'm looking for a way to have our total part cut/burn length (combination of outside & inside) for our SW part files and have this total distance information displayed on our drawings? I'm sure this would involve a macro or something similar to achieve this and was wondering if anyone else has done this. Any help would be greatly appreciated. Thanks in advance.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Total part cut length
- Thread starter prooney
- Start date
- Status
Similar threads
- Question
