Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations JStephen on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Torsion problem on a flat sheet

Status
Not open for further replies.
Jonny Flowers

Jonny Flowers

Mechanical
Joined
Jan 18, 2017
Messages
1
Location
GB
I have a flat sheet that I am applying a torsion to at 2 ends. However the issue I seem to be having is that the rotational displacement seems to only go a couple of degrees and stop. I have my base fixed using ENCASTRE and the top is related to a reference point that I can apply a rational displacement of 1 rad or 10 rad and it still turns the same amount. Any ideas?
 
Sort by date Sort by votes
- Is the analysis nonlinear with NLGEOM?
- Deformation scale factor set to 1 in postprocessing?
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Adil Memet
  • Question Question
Abaqus Metallurgical phase transformations simulation example running problem
Replies
6
Views
8K
Adil Memet
Adil Memet
E
  • Locked
  • Question Question
Mesh Problem
Replies
1
Views
2K
FEA way
FEA way
G
  • Locked
  • Question Question
Abaqus explicit - general contact problem
Replies
5
Views
18K
FEA way
FEA way
B
  • Locked
  • Question Question
Concentrated Force on a Rigid body reference point
Replies
2
Views
3K
Vishakh_Rajendran
Vishakh_Rajendran
IcarusAero223
  • Question Question
Mesh singularity on non-manifold geometry
Replies
5
Views
11K
IcarusAero223
IcarusAero223

Part and Inventory Search

Sponsor

Back
Top