toolbar customisation

[moog2]

how can i remove the separators from my toolbars...i'm hoping it will help stop them switching shape.
I run 2 monitors, and have all the toolbars over on the RHS, i prefer to stretch all the toolbars as long as they'll go, but when i swap between modelling and drafting, they re-set their shape to suit themselves.
This is NX3, i remember finding it in customisation once before, and it seemed to help, but i think it may have been in a previous release (or maybe it was NX4 )

 

[JohnRBaker]

With the toolbars displayed that you wish to edit, go to Tools -> Customize... Once in the customize mode, select the icon AFTER the separator that you wish to remove and press MB3 and toggle OFF the 'Begin a Group' item.


John R. Baker, P.E.
Product 'Evangelist'
NX Product Line
SIEMENS PLM Software Inc.
Cypress, CA

http://www.siemens.com/plm

http://www.plmworld.org/museum/

 

[moog2]

great, thanks John...