Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Too close warnings

Status
Not open for further replies.
Ahmad Alhamad

Ahmad Alhamad

Structural
Joined
Mar 8, 2017
Messages
24
Location
JO
Hello,

when i export revit model to Etabs too close warnings appeared as shown in pictures.
the warnings go away by dividing the beam at joints
is this the logical solution ?
too_close_j3cnlk.png

too_close_beams_lhumq6.png
 
Status
Not open for further replies.

Similar threads

PSR_1
  • Locked
  • Question Question
ETABS MODEL CHECKING MEMBERS TOO CLOSE TO EACH OTHER
Replies
2
Views
2K
Agent666
Agent666
PSR_1
  • Locked
  • Question Question
COMMENT ON CSI ETABS [OTHER PROGRAMS TOO] REGARDING EUROCODE 8
Replies
0
Views
252
PSR_1
PSR_1
alibajwa42
  • Locked
  • Question Question
etabs model anaylsis run too long and not finishing
Replies
3
Views
1K
chekre
chekre
ibrahemnasr
  • Locked
  • Question Question
ETABS Warnings " EIGENVALUES WAS FOUND OUT OF SEQUENCE"
Replies
4
Views
2K
inggelu
inggelu
jenofstructures
  • Locked
  • Question Question
ETABS Tool/Menu Bar
Replies
1
Views
689
slickdeals
slickdeals

Part and Inventory Search

Sponsor

Back
Top