Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Too close warnings

Status
Not open for further replies.
Ahmad Alhamad

Ahmad Alhamad

Structural
Mar 8, 2017
24
Hello,

when i export revit model to Etabs too close warnings appeared as shown in pictures.
the warnings go away by dividing the beam at joints
is this the logical solution ?
too_close_j3cnlk.png

too_close_beams_lhumq6.png
 
Status
Not open for further replies.

Similar threads

PSR_1
  • Locked
  • Question
ETABS MODEL CHECKING MEMBERS TOO CLOSE TO EACH OTHER
Replies
2
Views
2K
Agent666
Agent666
PSR_1
  • Locked
  • Question
COMMENT ON CSI ETABS [OTHER PROGRAMS TOO] REGARDING EUROCODE 8
Replies
0
Views
176
PSR_1
PSR_1
alibajwa42
  • Locked
  • Question
etabs model anaylsis run too long and not finishing 1
Replies
3
Views
784
chekre
chekre
ibrahemnasr
  • Locked
  • Question
ETABS Warnings " EIGENVALUES WAS FOUND OUT OF SEQUENCE" 1
Replies
4
Views
1K
inggelu
inggelu
jenofstructures
  • Locked
  • Question
ETABS Tool/Menu Bar
Replies
1
Views
488
slickdeals
slickdeals

Part and Inventory Search

Sponsor

Back
Top Bottom