billference
Mechanical
Can anyone tell me anything about this standard that was referenced in the title block of my customer's (GM) drawing?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tolerance Standards (A. I. 2400)
- Thread starter billference
- Start date
- Status
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question