Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tolerance stack up for rectangular pattern of holes

Status
Not open for further replies.

vellingiri78

Mechanical
Joined
Aug 17, 2015
Messages
6
Location
SG
Hi All,

We have a sheet metal bracket has rectangular pattern of holes (8 x 8) for M12 bolt, on which an equipment weighing 800 kg will get mounted.
Pleas help me to do tolerance stack up for this assembly.

Regards
Vellingiri
 
Question: do you REALLY (and again REALLY) expect to get ANY answers for your question?
 
Yes, i am looking for some material for study and understand the stack up.
Some guidance from members
 
Then try to following book:
"Mechanical Tolerance Stackup and Analysis" by Bryan R. Fischer (Advanced Dimensional Management)"

I am sure other memmbers will give you other excellent materials for the stackup study.

 
Thanks Greenimi..

Can we get soft copy of the book ?
 
That will be against the policy of this website (promoting and distribution of unlicenced materials)-End User License Agreement (EULA)
 
Well, the position tolerance analysis in appendix B of ASME Y14.5M-1994 may be adequate.

Posting guidelines faq731-376 (probably not aimed specifically at you)
What is Engineering anyway: faq1088-1484
 
Thnka you for your information, will get and do it
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top