Title under ISO view

[dthom0425]

Hi all - just a quick question.

Is it mandatory per ASME standards to add a view title to an isometric view? I'm not seeing anything in Y14.3 that would indicate this is a requirement. Normally, on our drawings, I see

ISOMETRIC VIEW
FOR REFERENCE ONLY

Just curious if there's an actual ASME requirement to do this. We end up putting ourselves into a situation of generating non-value added redlines when someone forgets to put the above note below the ISO view.

Thanks

 

[CheckerHater]

If you look into ASME Y14.3-2003 MULTIVIEW AND SECTIONAL VIEW DRAWINGS you will see that isometric view is NEVER given a title:

Naturally, notes can be added if the view is made not to scale, placed on different sheet, etc., etc.

"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future

 

[drawoh]

CheckerHater

"NEVER"?

I usually do not apply titles to drawing views, since it generally is obvious what they are. If I have notes or a separate document that refer to drawing views, then the views need to be labelled.

--
JHG

 

[CheckerHater]

I take it you only read first line

"For every expert there is an equal and opposite expert"
Arthur C. Clarke Profiles of the future