I was wondering if anyone could share any assembly tips for a beginner (assembly is my worst component)? I know how all the constraints work, but sometimes it takes me a while to snap my part into place or sometimes I find it difficult to select the center axis of a circle?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Tips and tricks for Assembly?
- Thread starter Baratheon
- Start date
Hi,
You can search this forum with keywords tip, trick, best practice or others, there are a lot of threads from which you can get some good advices.
Regards
Fernando
You can search this forum with keywords tip, trick, best practice or others, there are a lot of threads from which you can get some good advices.
Regards
Fernando
- Status
Similar threads
- Locked
- Question