Looking for some advice. I want to do some parametric limit load analysis using Ansys Workbench. I need to make the time at the last converged solution (same as restart time)a parameter. I want to use an APDL Solution command line (i.e., *GET,My_Value,...) to get the Commands(APDL) Result and then make it parametric. I can't figure out how to do it. The value I need is shown in the Solution Information. Thanks
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Time at Last Converged Solution
- Thread starter KBob1
- Start date
Similar threads
- Locked
- Question
- Locked
- Question