Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

TIEBACKS-WINSTABL

Status
Not open for further replies.
geohec

geohec

Geotechnical
Joined
Apr 12, 2007
Messages
19
Location
US

WinStabl Users:

I'm using the software for a current project application with tieback anchors.
Currently the program wont run. I think I might be doing something wrong in the data entry, either: boundary number or y-coordinate.
Does anyone might have an insight on this data entry procedure?
Thank you!
 
Sort by date Sort by votes
You would help the readers to follow your question if you scan a copy of the cross section and rough out the search limits somehow and post as a file as indicated below. jpg file seems to work OK..
 
Upvote 0 Downvote
I am not familiar with WinStabl, but often times it is possible to e-mail your input file to tech support for the program. Then, and after you have read the manual and looked through the examples, they can help walk you through the input to find your problem.

 
Upvote 0 Downvote
If need be I can get the phone number for the professor at Univ. Wisconsin. BigH may have it also.
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

geohec
  • Locked
  • Question Question
WinStabl-program from UW-Madison
Replies
2
Views
337
jdonville
jdonville

Part and Inventory Search

Sponsor

Back
Top