Thru hole without the THRU annotation

[EvilFlo]

Hello,
Is there a way for CREO to not display the word THRU in the callout when I have a thru hole?

 

[robertib]

You will need to create a custom note since, by default the hole notes call up the depth of the hole & the thread if using the hole tables - however if you don't use the hole table, you don't get a hole note unless you specifically create a setup note attached to the hole.

 

[EvilFlo]

Hello Robert,
I found from the ptcusercommunity that I can customize the hole table more than I thought possible.

http://help.ptc.com/creo_hc/creo30_...ng/part_nine_sub/Formatting_Thread_Notes.html

 

[dross]

I never use the notes that Creo provides.
They are too long and contain unesecessary information.