Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

threaded holes in sp1.1

Thread starter Yogibear
Start date Mar 9, 2005

Status: Not open for further replies.

Mar 9, 2005

Yogibear

Mechanical

I was going to put in another enhancement request to show the threads in a lin pattern of a HW feature the other day, but noticed that the threads didn't show up in the 1st instance in sp1.1 Well after talking to my VAR and a lot of tweeking I finally got the threads to show up, but only in the 1st instance. My VAR said that they can see all of the threads in the pattern. I was wondering if anyone else has seen this and/or knows the options that need set for it to work correctly. Also for a Tappered tap I see the threads showing up on the pre-drill.