Threaded Holes in a Hole Table

[Speedy]

Is it possible to add threaded holes to a hole table.

I've tried it - it doesn't seem possible. Straight holes are working fine for me. The help notes say that hole tables only apply to straight holes.

I have a drawing with up to 70 holes on a flat plate, about 3/4 of these holes are threaded. Using a hole table would be ideal.

Any suggestions?
It will save me a lot of work and hassle if I can figure this out !!!

 

[cadcamguy]

this might give you some options....

http://www.proe.com/connectqna_subm...19&PHPSESSID=41a93b053481353459803d721a54476b

http://www.ptcuser.org/exploder/pro-user/200304/msg00318.html

 

[Speedy]

Cadcamguy,
Thanks for your help, but as I understand it your suggestions refer to ISO.hol which specify the input tables for the holes, not the 'Hole Table' which is essentially a report in a drawing.

I found the following

http://www.sigmaxim.com/html/smartholechart.html

Looks like this is what I need.

Anybody ever used this?
Speedy

 

[cadcamguy]

ahh .. hole chart..

sweet find speedy

can't tell you much abou that but hsve heard good things about smart electrode

http://www.sigmaxim.com/html/smartelectrode.html