ansys_UG
Mechanical
- Jul 25, 2018
- 1
thread569-301450
i just re-loaded the parasolid(IGES) back into Unigraphics NX8, then saved AGAIN over the IGES file a second time. I didnt get error as well. I dont how that possible but it worked. It has somthing to do with the ansys i guess.
i just re-loaded the parasolid(IGES) back into Unigraphics NX8, then saved AGAIN over the IGES file a second time. I didnt get error as well. I dont how that possible but it worked. It has somthing to do with the ansys i guess.