thread561-373973 TO copy a attri

[Sarath_dtm]

thread561-373973

TO copy a attribute of a Part (For Example say callout) to a clipboard in following format <W!xxxxx@CALLOUT>, Is there any Journal file available with NX 12 supporting format?

 

[niedzviedz]

It should works on NX12. Do You receive any errors when running journal?

With best regards
Michael

 

[Sarath_dtm]

I didn't receive any error. However, it stops after the prompt "select the component". After selecting the component its closed/stopped.

 

[niedzviedz]

I tested it and when You select component without attribute the warning window appear, but when attribute exist, journal copy it to clipboard without any info. Then You can paste it to i.e. .notepad

With best regards
Michael

 

[Sarath_dtm]

Many thanks. I'll give it a try and I'll post the feedback tomorrow.

 

[Sarath_dtm]

Hi Thanks. Yes it works.