Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thread286-337858 Sorry I'm a lat

Status
Not open for further replies.
RPShaffer

RPShaffer

Structural
Joined
Aug 21, 2017
Messages
1
Location
US
thread286-337858

Sorry I'm a late comer to this thread. I have been tasked with doing UT inspection for toe cracking after galv and wondered if anyone knew of an established procedure that could be referenced.
Any help is appreciated.
Thanks.
Randy
 
Status
Not open for further replies.

Similar threads

dogbural
  • Locked
  • Question Question
MMC to a diameter
Replies
2
Views
1K
3DDave
3DDave
O
  • Locked
  • Question Question
points to capture on a 3D measurement
Replies
4
Views
2K
IRstuff
IRstuff
InselR
  • Locked
  • Question Question
Testing a diode on 3500 RPM
Replies
4
Views
990
3DDave
3DDave
ASIT859
  • Locked
  • Question Question
FARO Cam2 - Straight Slot Surface Datum A, Flat Surface Datum B Inspection?
Replies
0
Views
867
ASIT859
ASIT859
MCQE
  • Locked
  • Question Question
PED WELDER QUAL ON A PRODUCTION PART
Replies
2
Views
407
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top