Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thread286-337858 Sorry I'm a lat

Status
Not open for further replies.
RPShaffer

RPShaffer

Structural
Aug 21, 2017
1
thread286-337858

Sorry I'm a late comer to this thread. I have been tasked with doing UT inspection for toe cracking after galv and wondered if anyone knew of an established procedure that could be referenced.
Any help is appreciated.
Thanks.
Randy
 
Status
Not open for further replies.

Similar threads

dogbural
  • Locked
  • Question
MMC to a diameter
Replies
2
Views
1K
3DDave
3DDave
O
  • Question
points to capture on a 3D measurement
Replies
4
Views
2K
IRstuff
IRstuff
InselR
  • Locked
  • Question
Testing a diode on 3500 RPM
Replies
4
Views
865
3DDave
3DDave
ASIT859
  • Locked
  • Question
FARO Cam2 - Straight Slot Surface Datum A, Flat Surface Datum B Inspection?
Replies
0
Views
767
ASIT859
ASIT859
MCQE
  • Locked
  • Question
PED WELDER QUAL ON A PRODUCTION PART
Replies
2
Views
292
SWComposites
SWComposites

Part and Inventory Search

Sponsor

Back
Top Bottom