Thread Class not shown by default

[takedownca]

I'm not sure when it changed, but now when I add a threaded hole the Thread Class is unchecked by default and the hole callout doesn't show it either. This applies to both 2007 and 2008. I can manually check the Thread Class option, but I distinctly remember that in 2006 the thread class used to show up in drawing hole callouts by default. Any ideas are appreciated.

 

[fcsuper]

I'm having the same problem. My VAR didn't have a resolution

Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group

 

[takedownca]

Well, at least I'm not a lone duck.

 

[CorBlimeyLimey]

Maybe, you could modify the callformat.txt file to suit.

 

[fcsuper]

There's no settings that apply to this in calloutformat.txt...just the callout format itself. It's something that is added by Hole Wizard when it creates the tapped hole feature.

As far as I know, there's no API access for it either.

Matt Lorono
CAD Engineer/ECN Analyst
Silicon Valley, CA
Lorono's SolidWorks Resources
Co-moderator of Solidworks Yahoo! Group
and Mechnical.Engineering Yahoo! Group