Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

This pisses me off

Thread starter Buranelli
Start date May 4, 2020

Status: Not open for further replies.

May 4, 2020

Buranelli

Civil/Environmental

I'm modelling a slab on the ground, everything goes fine until I was looking how polluted the Shell Stresses graphics are. There was this green symbols everywhere. I tried to turn them off with no success.
Can someone tell me how turn off this light green Z shaped symbols? (see the images bellow)