Hello Everyone, I am using CSI Bridge and I noticed that the program automatically assigns end length offset. Is there away to control it? I know I can manually change it but the issue is when I update the bridge model, it resets itself to what was automatically assigned on the first place. Have anyone experienced the same issue? Thanks.
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
CSI Bridge_End Length Offset
- Thread starter yaroosh
- Start date
Similar threads
- Locked
- Question
- Locked
- Question
- Locked
- Question
- Locked
- Question