Eng-Tips is the largest forum for Engineering Professionals on the Internet.

Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!

Register Log in
  • Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Thickness of tubes Sec IV HG-301.2 and HF-204.3

Status
Not open for further replies.
Konrad

Konrad

Mechanical
Joined
May 20, 2002
Messages
84
Location
SE
I'm using stainless austenitic tubes welded to stainless tubesheet in a small hot water heater. Does HF-204.3 exempt from HG-301.2(b) 1.5mm minimum thickness?

Thanks
Konrad
 
Status
Not open for further replies.

Similar threads

Karik87
  • Question Question
Combine thickness and diameter qualified range of welder according to ASME IX
Replies
4
Views
1K
Karik87
Karik87
K.P.M.
  • Question Question
Manufacturer Design report // ASME Sec VIII Div 2
Replies
1
Views
1K
TGS4
TGS4
victor6397
  • Question Question
Question about Ratcheting (ASME Sec. VIII Div.2)
Replies
6
Views
15K
victor6397
victor6397
nashki
  • Question Question
Thickness Hub at the Small End, g0
Replies
5
Views
8K
r6155
r6155
FAHADRANA
  • Locked
  • Question Question
WQT for Combination of Welders as per ASME Sec IX
Replies
3
Views
4K
DekDee
DekDee

Part and Inventory Search

Sponsor

Back
Top