Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Thermoshipon reboiler return line
- Thread starter AnhsirkT
- Start date
There is no "rule of thumb" about changes to the design of these important process return lines..
Your question is really about the return line maximum pressure drop, which should have been considered during the equipment layout stage of the project..... Are you trying to relocate the Thermosiphon reboiler from an existing position ?
This may help:
MJCronin
Sr. Process Engineer
Your question is really about the return line maximum pressure drop, which should have been considered during the equipment layout stage of the project..... Are you trying to relocate the Thermosiphon reboiler from an existing position ?
This may help:
MJCronin
Sr. Process Engineer
- Thread starter
- #3
- Thread starter
- #4
- Thread starter
- #8
georgeverghese
Chemical
Bends are okay, but there should be no low point pockets in reboiler 2 phase return line, and line should slope continuously down to column product sump.
- Status
Similar threads
