I'm looking for a second (or third) set of eyes for my thermal expansion design. It's a 12 story building and I'm looking at 2" CPVC domestic hot water (140 °F) piping. See my attached markups where I show expansion joints, guides, and anchors; does this look okay? Am I missing anything? Any tips are appreciated.
Eng-Tips is the largest forum for Engineering Professionals on the Internet.
Members share and learn making Eng-Tips Forums the best source of engineering information on the Internet!
-
Congratulations dmapguru on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Thermal expansion in riser shaft
- Thread starter nuuvox000
- Start date
Similar threads
