thermal-electrical modeling in ABAQUS

[naltang]

I tried to do thermal-electrical modeling. but due to an error, I could not go on.
The error message says, "000 elements have missing property definition".
I had put density, specific heat, conductivity, electical conductuvity and joule heat fraction.
What else are needed? Thanks

 

[corus]

Most probably it means you've not assigned the properties.

corus

 

[xerf]

Did you assign the proper element type ?

 

[naltang]

The element type was DC2D4E because it was 2-D, electo-thermal model. Is this element type proper?