Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

thermal condition

Status
Not open for further replies.
giamma109

giamma109

Mechanical
Joined
Aug 29, 2006
Messages
27
Location
IT
Hi to everybody,

I have a shaft with a fan forced-fit ( steel for the shaft and plastic for the fan), I have to consider a thermal load of 130°C because the assembly (fan+shaft)work at these temperature and I want to evaluate if the fan remain fit(with the contact tool). I consider only 1/4 of the geometry for the simmetry and I use a "frictional support", is it correct?

Thks
 
Status
Not open for further replies.

Similar threads

LS_SMS
  • Question Question
Applied Acceleration At Boundary Condition
Replies
2
Views
6K
dgeesaman
dgeesaman
W
  • Question Question
Trying to couple a transient thermal and structural simulation but I get zero deformation and stress
Replies
0
Views
2K
weldtest12
W
shiraz883
  • Locked
  • Question Question
Stresses increase on adding thermal boundary conditions/ thermal load
Replies
1
Views
472
SWComposites
SWComposites
Faraz1997
  • Locked
  • Question Question
How to reduce number of iterations in tabular data of transient thermal analysis
Replies
3
Views
1K
NRP99
NRP99
V
  • Locked
  • Question Question
Boundary conditions and post processing for Planar tension test
Replies
0
Views
584
vsw
V

Part and Inventory Search

Sponsor

Back
Top