thermal analysis using pro engineer ????

[Ayah]

Hello all,


Ihave some question about making a thermal analysis for a shaft of a car.....


1-Can you give me the steps for createing a shaft using pro-engineer???


2-How I can determine the raduis of the shaft and the length of it??? and how I can determine the forces and torques that effect on the shaft???


3-plz anyone can help me in doing a thermal analysis using the ansys or pro engineer after create the shaft????


thank you


Bye

 

[nschlueter]

http://www.ptc.com/community/resource-center/proengineer/

This will have tutorials and a library of parts.

If you need the analysis performed, I can help you with
that as well.

http://www.eacpds.com/pdc_site/flashmo_117_artistic.html