Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Testing underground tanks; groundwater vs in-tank pressures

Status
Not open for further replies.

GuyG

Specifier/Regulator
Jul 3, 2001
2
As a UST regulator, we review untold numbers of tank integrity tests in which the groundwater level relative to the product level are ignored, at worst, or estimated, at best. Manufacturers tell us there must be from one-half (1/2) pound to one (1) pound psi on the bottom of the tank, so both the groundwater level and the product level must be considered. In addition, of course, the density or specific gravity of the product must be considered. Does anyone have a notion how to calculate the necessary levels (either with water above the product or vice versa) in order to accomplish the requisite pressure on the bottom of the tank? Thanks.
GuyG
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor