Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations MintJulep on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Temporary Water Main and Cross Connections

Status
Not open for further replies.

mflam

Civil/Environmental
Joined
Apr 12, 2005
Messages
30
Location
US
Should an above ground temporary water main be considered a potential source of contamination?
Should it be isolated from the permanent system with backflow preventers?
What if it is looped into the permanent system at two points?
The loop configuration makes the system more robust and supplements fire flows but, of course, backflow prevention would at the points of connection would prevent the main from acting as a loop.
 
Seems like it would depend on what type of piping was installed. If you installed water main grade pipe for a temporary service, why would you need a back flow preventer?

On the other hand, if you jury rigged some piping or perhaps installed the piping in an area exposed to flooding, you may have some concerns.

 

What about the psychologists question: what do you think yourself?
:-)

In my opinion contamination could only occur by breakdown, puncture or lasking into the aboveground loop, or by increasing growth of existing bacteria (unclean/contaminated) pipeline installed by stillstand in the loop.

Any other points? What do the local authorities say?

 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top