I am designing a temperature measurement circuit for measuring temperature of a oven. Temperature of the oven is around 650 K. I heard that thermistors and RTDs can be used for temperature measurements. But I couldn't figure out which is better. Can somebody give some suggestions ?
Tek-Tips is the largest IT community on the Internet today!
Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!
-
Congratulations JAE on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!
Temparature measurement
- Thread starter Reeq
- Start date
You won't be finding a thermistor for a temperature that high. 250°C is about the upper limit.
As for which is better, VE1BLL's thermocouple suggestion or an RTD: You need to consider the desired accuracy, cost, package, range, and other things.
Best to you,
Goober Dave
Haven't see the forum policies? Do so now: Forum Policies
As for which is better, VE1BLL's thermocouple suggestion or an RTD: You need to consider the desired accuracy, cost, package, range, and other things.
Best to you,
Goober Dave
Haven't see the forum policies? Do so now: Forum Policies
engineeringcalc
Industrial
RTDs are resistors, with a value that changes usually with the temperature. The more common type is PT100. However I think it is a very high temperature for a PT100. For that temperature I believe the correct choice would be a Thermocouple. Thermocouples provide a very week voltage signal, that you will have to handle with the proper electronic. There are many devices in the market that can read the thermocouple and provide a analog (4-20mA) signal that you can handle with a PLC etc.
Regards,
Regards,
btrueblood
Mechanical
400 C is well within the usable range (to 600 C) for a platinum RTD, if it is properly constructed for high temp's. RTDs have better accuracy, linearity and repeatability than thermocouples, so may have advantages there. Whatever device is used, it should be designed to be fairly readily removed for calibration and/or replacement when it eventually breaks.
- Status
