Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Register Log in
  • Congratulations waross on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tek Screw Technical Data

Status
Not open for further replies.
dncr

dncr

Structural
Mar 10, 2003
1
I am looking for published data on "Tek Screws". Pullout strength, shear capacity, Pullover limits etc. I am aware of the information in the Hilti Catalogue but am looking for more extensive information.
 
Replies continue below

Recommended for you

Sort by date Sort by votes
sixth edition of FASTENER STANDARDS from Industrial Fasteners Institute, 1978, shows SAE J78 as an appropriate standard.

Griffy
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

JLBK56
  • Locked
  • Question
Wood Screw Thread Form
Replies
7
Views
511
phamENG
phamENG
Erin Foster
  • Locked
  • Question
304 Stainless Steel Screw for 316 Stainless handle?
Replies
5
Views
277
EdStainless
EdStainless
GTrinh97
  • Locked
  • Question
Screws and Nails
Replies
3
Views
281
3DDave
3DDave
jsu0512
  • Locked
  • Question
When screw is subject to shear load with the shim between the joint
Replies
1
Views
275
dhengr
dhengr
LucasVidler
  • Locked
  • Question
Screw holding Loudspeaker in wood box is loosening - Spring Washer? 1
Replies
15
Views
310
dik
dik

Part and Inventory Search

Sponsor

Back
Top Bottom