Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

Register Log in
  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tapered Tape

Status
Not open for further replies.
gab4055

gab4055

Aerospace
Joined
Jul 15, 2002
Messages
14
Location
US
I am looking for Tapered tape of film with a adhesive back. Aprox. 1.25" wide and .012 thick at one edge and .001-.002 at the other. the tape would heve to stand 350 Deg F. for 10 hours. Anyone have any ideas??
 
Sort by date Sort by votes
I would think that the adhesive by itself would be thicker than .002". Does the strip have to be non-metallic? If the length isn't critical and metal can be used, you may be able to have the metal strip surface ground to the correct taper, although the thin end, with adhesive, will probably be .003-.004, IMO.
 
Upvote 0 Downvote
The length would have to be 480 inches or so. And it would have to stay in place at temperatures of 350 deg. F
 
Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

alan_young_1983
  • Locked
  • Question Question
Custom tapered standoff ??
2
Replies
20
Views
851
SwinnyGG
SwinnyGG
racookpe1978
  • Locked
  • Question Question
Tape Measure Falls 50 Stories, 1 Dies Below (No Hardhat)
Replies
1
Views
218
chicopee
chicopee
bigj4
  • Locked
  • Question Question
Sandvic Capto spindle taper regrinding
Replies
0
Views
112
bigj4
bigj4
tronics21
  • Locked
  • Question Question
best way to manufacture tapered tubes?
Replies
4
Views
244
KENAT
KENAT
SpinFast
  • Locked
  • Question Question
Taper or Flange Design for Drive Shaft of High Speed Centrifuge
Replies
3
Views
352
TVP
TVP

Part and Inventory Search

Sponsor

Back
Top