clownfish01
Mechanical
- Jun 2, 2010
- 1
Hi,
I'm trying to design a good taper seal for a conical polypropylene part going into a plastic (e.g. ABS) manifold. Does anyone know of a good design reference for sizing the two parts, given that some deformation is expected, to make a good seal? Or if you have designed such a part before, I would appreciate any advice you have to offer!
Many thanks!
I'm trying to design a good taper seal for a conical polypropylene part going into a plastic (e.g. ABS) manifold. Does anyone know of a good design reference for sizing the two parts, given that some deformation is expected, to make a good seal? Or if you have designed such a part before, I would appreciate any advice you have to offer!
Many thanks!