Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

  • Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tanks materials for lime slurry, magox slurry and soda ash solution

Status
Not open for further replies.

JasonLouie

Materials
Aug 13, 2007
56
I have been trying to find information on materials selection for water treatment plants but have come up empty handed. We have a hot lime softener in our water treatment plant and we need to specify the materials of construction for storage tanks for the following chemicals:

5-20% lime slurry
5-20% magox slurry (magnesium oxide)
5-20% soda ash solution

One vendor has offered carbon steel with 1/16" CA. I have tried looking up calcium oxide, calcium hydroxide, magnesium oxide and sodium carbonate and my corrosion tables do not have much useful information for carbon steel. Can anyone offer suggestions for the materials, or tell me if carbon steel is good for these storage tanks?

I appreciate any help anyone can provide!
 
Replies continue below

Recommended for you

If you look at this paper, you will see that carbon steel will not significantly corrode when the solution pH is above 8.3. The pH of your solutions will all be elevated.


Years ago, carbon steel was the material of choice for industrial projects where these solution tanks were commonly used. It is probably more common to make these tanks of plastic today, because plastic tanks are readily available. You can use almost any type of plastic such as polyethylene or FRP. The choice of material will depend somewhat on the size of the tank.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor