Tek-Tips is the largest IT community on the Internet today!

Members share and learn making Tek-Tips Forums the best source of peer-reviewed technical information on the Internet!

  • Congratulations TugboatEng on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

Tank Anchorage

Status
Not open for further replies.

elhamydy

Mechanical
Joined
Mar 19, 2020
Messages
5
Location
MA
Hi All
I have a question how to find the information below for Tank Anchorage :
-N [dless] = Number of bolts selected
-Db [mm] = Bolt nominal diameter

And if any one have the document AISI E-1 specification, Volume ll, part VII,

Tanks in advance
Best Regards
 
Is this an API-650 tank ?

API-650 contains rules about the number of anchor bolts, spacing and bolt sizes

MJCronin
Sr. Process Engineer
 
Assuming anchorage is required, calculate the minimum number of bolts required based on maximum bolt spacing, and round up to a multiple of 4.
Calculate root area required per bolt, look in tables of bolt properties to find what size bolt that is.
Include corrosion allowance and minimum bolt sizing requirements if applicable.
If the bolt size or the anchor chair comes up unreasonably large, then increase the number of bolts and try again.
 
Status
Not open for further replies.

Part and Inventory Search

Sponsor

Back
Top