Dear colleagues,
i'm beginning to use patran, so please excuse me for banality.
I'm doing a model (a ship deck) made by a mapped mesh. The analisys was imposed as explicit non linear but, with introduction of some contact i would change it to implicit non-linear.
It's possible to do this after generating the mesh?
tank you for help
i'm beginning to use patran, so please excuse me for banality.
I'm doing a model (a ship deck) made by a mapped mesh. The analisys was imposed as explicit non linear but, with introduction of some contact i would change it to implicit non-linear.
It's possible to do this after generating the mesh?
tank you for help