Continue to Site

Eng-Tips is the largest engineering community on the Internet

Intelligent Work Forums for Engineering Professionals

Congratulations cowski on being selected by the Eng-Tips community for having the most helpful posts in the forums last week. Way to Go!

SW2005 SP2.0 question

Thread starter darnell
Start date Mar 22, 2005

Status: Not open for further replies.

Mar 22, 2005

darnell

Mechanical

I noticed that this sp was available so I downloaded it today. I also noticed that all the other products were available too. I couldn't tell i fthey had been updated so I downloaded all of them as well. We have a batch file that runs after the install. When I put the path in for the DWGeditor setup.exe, it errors out in the batch file. They show some possible switches. Does anyone else do this and can tell me witch switch /v /s or what will work?

Thanks